Manual

Chapter 7: System Operations
7.3.6 Parameter copy.
To speed parameter data entry, it may be beneficial to copy from one parameter set to
another parameter set. This is especially the case if o
the procedure below for the parameter copy function using the display;
FIG. 7.3.6 Parameter copy procedure
Page 7-30
To speed parameter data entry, it may be beneficial to copy from one parameter set to
another parameter set. This is especially the case if o
nly minor changes are required. Use
the procedure below for the parameter copy function using the display;
•
When the system is in Setup mode,
select Data number 01 of Parameter 00
(This data corres
ponds to the ROM ve
sion and is non adjustable data.)
• Press the Set button
and the cursor
will jump to the left digit position of the 4
digit data display. (There will be a d
cimal point between the second and third
digit) The first two digits specify which
parameter number is to be copied
and the two dig
its after the decimal point
specify which parameter number is being
copied TO.
•
Edit the numbers to change the di
play to get the desired source and target
parameter numbers. (The example to the
left shows parameter 1 being copied to
parameter 2)
• Press the
SET button to proceed
with the copy.
•
Press either arrow button to confirm
the change (YES) or to cancel it (NO).
(The display will return to the Setup
Mode if no action is taken within 4
seconds)
•
If YES is displayed, press the SET
button again to copy the
parameter.
FIG. 7.3.6 Parameter copy procedure
To speed parameter data entry, it may be beneficial to copy from one parameter set to
nly minor changes are required. Use
When the system is in Setup mode,
select Data number 01 of Parameter 00
.
ponds to the ROM ve
r-
sion and is non adjustable data.)
and the cursor
will jump to the left digit position of the 4
digit data display. (There will be a d
e-
cimal point between the second and third
digit) The first two digits specify which
parameter number is to be copied
FROM
its after the decimal point
specify which parameter number is being
Edit the numbers to change the di
s-
play to get the desired source and target
parameter numbers. (The example to the
left shows parameter 1 being copied to
SET button to proceed
Press either arrow button to confirm
the change (YES) or to cancel it (NO).
(The display will return to the Setup
Mode if no action is taken within 4
If YES is displayed, press the SET
parameter.