Manual

FUSION Operations Manual
7.3.3
Parameter # selection
All 16
Parameter sets can be setup using the programmer. Data corresponding to the s
lected parameter number will be displayed in the [DATA] display. The diagram below d
scribes the selection.
p
rogramming purposes is accomplished by depressing the
zon
tal arrows) while in
PARAMETER 0 that contains configuration data common to all parameters.
FUSION Operations Manual
Chapter
7: System Operations (Rev.2)
Page 7-27
Parameter # selection
Parameter sets can be setup using the programmer. Data corresponding to the s
lected parameter number will be displayed in the [DATA] display. The diagram below d
scribes the selection.
Selection of the FUSION system 16 different sets of parameters for
rogramming purposes is accomplished by depressing the
[

] and [



tal arrows) while in
primary setup mode.
In addition to parameter 1 ~ 16 there is a
PARAMETER 0 that contains configuration data common to all parameters.
FIG. 7-3-3 Parameter display D-No selection
7: System Operations (Rev.2)
Parameter sets can be setup using the programmer. Data corresponding to the s
e-
lected parameter number will be displayed in the [DATA] display. The diagram below d
e-
Selection of the FUSION system 16 different sets of parameters for



] Cursor key (Hori-
In addition to parameter 1 ~ 16 there is a
PARAMETER 0 that contains configuration data common to all parameters.