Manual

Chapter 7: System Operations
7.3.2 Setup Mode selection
Depressing the Mode button will initiate the Setup mode. Immediately after the setup mode
is established, a blinking number will appear in the
(blinking mode) will move
between the 2 digit pos
pressed.
The blinking character can be increased or decreased using the [
The [COUNT/D-NO]
characters will display the data corresponding to the Parameter data list
(7.2.5). The [DATA] characters will display the actual value of the
rently set. You may edit the currently indicated
[SET] button to enter into the Data E
to change. (See 7.3.4
and 7.3.5
FIG. 7
Page 7-26
Depressing the Mode button will initiate the Setup mode. Immediately after the setup mode
is established, a blinking number will appear in the
[COUNT/D-NO.]
display. The cursor
between the 2 digit pos
itions
each time the [MODE] button is
The blinking character can be increased or decreased using the [
↓
↓↓
↓] and [
↑
↑↑
↑
characters will display the data corresponding to the Parameter data list
(7.2.5). The [DATA] characters will display the actual value of the
[COUNT/D-NO]
as it is cu
rently set. You may edit the currently indicated
data using the Data Edit mode. Press the
[SET] button to enter into the Data E
dit mode on the indicated [COUNT/D-NO.]
that
and 7.3.5
for detail)
FIG. 7
-3-2 Setup mode D-No selection
Depressing the Mode button will initiate the Setup mode. Immediately after the setup mode
display. The cursor
each time the [MODE] button is
↑
↑↑
↑
] buttons.
characters will display the data corresponding to the Parameter data list
as it is cu
r-
data using the Data Edit mode. Press the
that
you want