Manual

FUSION Operations Manual
7.3 Download / Setup Mode Operation (Bypass Mode Only)
The FUSION system has two
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC B
pass input. The operational modes available in the
der this condition
, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
BYPASS external signal is active. During the
lows setting of all available parameter presets.
7.3.1
Download Mode selection
Immediately aft
er the bypass condition has been entered, the unit is in the
Setup mode
with the unit number displayed on the Count /D
Console
software allows
program the
CONTROLLER
change to the
primary
communication to an external computer, the download mode will be maintained until the o
eration is co
mpleted.)
(Refer to the AFC
Console Manual for information about the Download Mode).
FUSION Operations Manual
Chapter
7: System Operations (Rev.2)
Page 7-25
7.3 Download / Setup Mode Operation (Bypass Mode Only)
The FUSION system has two
operational states that are controlled by depressing the
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC B
pass input. The operational modes available in the
Bypass State
are identified below. U
, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
BYPASS external signal is active. During the
Bypass State, the
controller
lows setting of all available parameter presets.
Download Mode selection
er the bypass condition has been entered, the unit is in the
with the unit number displayed on the Count /D
-
No Display
software allows
the CONTROLLER
Unit setup via a computer
CONTROLLER
unit with the display programmer, press the [MODE] key to
primary
setup mode. (If the CONTROLLER
unit is performing some data
communication to an external computer, the download mode will be maintained until the o
mpleted.)
Console Manual for information about the Download Mode).
Pressing both the [MODE] & [SET] keys at the same time
puts the controller into BYPASS mode.
FIG. 7-3-
1 CONTROLLER Unit in Download mode.
7: System Operations (Rev.2)
operational states that are controlled by depressing the
“MODE” and “SET” Buttons, on the front of the Controller, simultaneously, or by the PLC B
y-
are identified below. U
n-
, the “MODE” and “SET” Buttons have been pressed simultaneously, or the
controller
displays and al-
er the bypass condition has been entered, the unit is in the
initial Download /
No Display
. The AFC User
Unit setup via a computer
’s RS232 Port. To
unit with the display programmer, press the [MODE] key to
unit is performing some data
communication to an external computer, the download mode will be maintained until the o
p-
Console Manual for information about the Download Mode).
Pressing both the [MODE] & [SET] keys at the same time
puts the controller into BYPASS mode.
1 CONTROLLER Unit in Download mode.