Owner manual

enFORCE Operation Manual
PAGE 7 - 2
Chapter 7: Maintenance & Inspection
7.1 Inspection Items
A scheduled inspection is recommended to keep the enFORCE System in the best running
condition. A preventive maintenance routine should be set-up. Recommended inspection
schedules are given for each item.
Follow Lockout/Tagout and other safety precautions when connecting or
disconnecting cables, wiring, and equipment. When performing the following
inspections, verify that the System is disabled prior to touching any moveable
components.
7.1.1 Press Tool
Recommended Schedule: Quarterly
It is important to keep the tool clean and properly adjusted to ensure correct press and accurate
system outputs. Inspect each tool, and ensure the following conditions exist:
• All environmental conditions are within the specified ranges.
• The duty cycle is within specifications, and the motor is producing normal heat levels.
• The tool is producing normal levels of noise and vibration.
• The tool is free from excessive contamination and foreign matter.
• The tool is securely mounted, with mounting bolts properly tightened.
• The homerun cables are securely connected to the tool.
7.1.1.1 Lubrication
Recommended Schedule: 1 year or 1 million cycles minimum *
* Depending on environmental conditions, it may be required to lubricate more often. Inspect
press ram at start up for appearance of excessive lubricant deposits.
When required, lubricate according to the following guidelines:
• Use only Mobil Mobilith® SCH PM or Lube USA Luber® FS grease.
• Apply 10ml in each of the Gear Housing’s access ports and/or grease fittings.
• Apply 10ml in the Ball Screw access port/grease fitting (middle of press).
 DPT-301-** - ram must be advanced to 120mm to access lube point.
• Apply 20ml in the Rod grease fitting (lower portion of press).
7.1.2 Press Fixture
Recommended Schedule: Daily
• Ensure all light curtains and safety devices are operating properly - immediately shut
down press if any problem is found and do not operate until safety devices are in
proper working order.
• Ensure any fixture is securely attached to the press ram (and/or press base) and all
fasteners are tight.