Owner's manual

enFORCE SAN Unit Operation Manual
PAGE 6 - 45
Cha
p
ter 6: S
y
stem O
p
eration
6.5 Setting Up a Parameter for Returning
It is recommended that, if the return of the press is done with a parameter, use Distance Control.
However, if Target Distance is set to 0 without a return operation, the press will reject because the
Distance Low value is zero (a value less than zero is not possible).
Refer to the following for setting up a Return Parameter. Adjustments can be made according to
the individual application.
D-NO DATA SETTING
００ Press Operation ０００１ (Distance Control＋Return Operation)
１１
Load Low Limit
０
１２
Load High Limit Maximum Load of the Tool
１４ Press Speed Start Load 1 or Maximum Load of the Tool
１５
Interference Check Load Maximum Load of the Tool
１６
Distance Measurement Start Load
０
１７ Part Check Low Maximum Load of the Tool
２０
Distance Low Limit
０
２１
Distance High Limit
２
２２ Target Distance １ (setting to 0 will cause a reject)
２３
Interference Check Distance
３
２４
Press Speed Start Distance
２
３０ Advance Position ON Distance ０
３１
Advance Position OFF Distance
０ (if using Rates, set to maximum)
３２
Return Position ON Distance
０
３３ Return Position OFF Distance ０ (if using Rates, set to maximum)
４０
Slow Start Time
０
４１
1
St
Time High
１２０
４２ 2
nd
Time High １２０
５０
Slow Start Speed
１
５１
Approach Speed
１００
５２ Part Search Speed ５
５３
Press Speed
３
５４
Return Speed
５
６０ Approach Distance １０ (may need to set larger for higher speeds)
６１
Load Hold Time
０
６２
Job Start Position
０
６４ Distance Offset ０