User Manual


2.5 Nutrunner
{ Fastening accuracy (Torque): From 1/4 ~ full scale torque: 6
s
Less than 10%
{ Torque sample rate: Full Scale Torque X 1/1000
{ Torque display resolution: 4.5 digit display with floating decimal point.
{ Fastening accuracy (Angle): Within +1 degree
{ Angle sample rate: Below 0.036 degrees (dependent upon gear ratio).
{ Angle display resolution. 0.1 degree
{ Torque transducer accuracy: (Full Scale) ± 1%
{ Linearity of torque transducer:± 0.5%
NOTE: The tool lists located throughout this manual identify the specifications for the standard tools
used with the AFC1200 System. If additional information is required for special tool
assemblies, please contact FEC INC.
2.5.1 Nutrunner Specification Table
211066.6 :14,335360.05,00050.0490.0AXIS-210DFT-502M4-S/O
215064.8 :12,601216.03,00030.0294.0AXIS-205DFT-302M3-S/O
322045.0 :11,734144.02,00020.0196.0AXIS-205DFT-202M3-S/O
431531.5:11,300108.01,50015.0147.0AXIS-205DFT-152M3-S/O
439525.2 :11,12794.01,30013.0127.4AXIS-205DFT-132M3-S/O
550019.8 :169357.68008.078.4AXIS-205DFT-801M3-S/O
879012.6:152043.36006.058.8AXIS-205DFT-601M3-S/O
550019.8 :134628.84004.039.2AXIS-203DFT-401M2-S/O
325039.6 :134628.84004.039.2AXIS-203DFT-401M1-S/O
550019.8 :117314.42002.019.6AXIS-203DFT-201M1-S/O
550019.8 :1867.21001.09.8AXIS-203DFT-101M1-S1/O1
MINMAXINLBFTLBKGCMKGMNM
SPEEDGEAR
RATIO
FULL SCALE TORQUESERVO
TYPE
TOOL TYPE
TOOL SPECIFICATIONS
CONVERSION GUIDE: 1 KGM = 100 KGCM = 9.8 NM = 7.2 FTLB = 86.7 INLB
Chapter 2: Specifications User Console Version A3.53
Page 2-6