User guide


SEQ OUT 4DATA 7
SEQ OUT 3DATA 6
SEQ OUT 2DATA 5
These four outputs are available to indicate
that the fastening sequence has reached a
step that has an out port [OUT] command
inserted. Used to provide sequence operation
status out to the PLC.
SEQ OUT 1DATA 4
SPARESPAREDATA 3
SPARESPAREDATA 2
Reserved for future use.HD FULL WRNDATA 1
Output when System is in Program mode.PROGRAMDATA 0ONOFF2
SEQUENCE 2DATA 7
SEQUENCE 1DATA 6
Output confirmation of SEQUENCE SELECT
0~2 (Pins 9~11) input selections.
SEQUENCE 0DATA 5
Output after a START signal is received and
active until the fastening cycle is complete and
the READY signal is output. System will also
output this signal when performing a Zero, Cal,
or Offset Check.
BUSYDATA 4
Output when the System is in READY
condition. Indicates the System is ready to
operate and inputs are enabled. This signal is
inactive (off) when the BUSY output is active
(on).
READYDATA 3
Output when a System Abnormal occurs.
Indicates that the System has detected a fault
and will not continue operation. The Abnormal
code/description is displayed on the front of the
Axis Unit and/or on the System CRT. The
Abnormal condition must be corrected before
normal operation will resume. Refer to Chapter
9 Troubleshooting.
ABNORMALDATA 2
Output when the fastening result is an
ACCEPT. Indicates all spindles are within
fastening limits. This output remains active
until the START signal or RESET signal is
input.
ACCEPTDATA 1
Output when the fastening result is a REJECT.
Indicates one (1) or more spindles has
exceeded fastening limits. This output remains
active until the START signal or RESET signal
is input.
REJECTDATA 0OFFOFF1
DESCRIPTIONNAME OF
SIGNAL
BANK DATA
PINS 23~30
0
PIN 21
1
PIN 22
BANK
#
PLC1 BANK DATA
BANK
SELECT
INPUT
Chapter 4: System Setup and Wiring
Page 4-22