Manual


The information displayed in DSP 1 and DSP 2 on the Axis Unit is determined by the ISA
Main Controller Unit's AXIS-DSP switch setting. The two display outputs for each switch
setting are shown below.
PEAK CURRENTCYCLE TIME8
FINAL TORQUEOFFSET TORQUE7
ELONGATION ANGLEELONGATION TORQUE6
2ND, 3RD, FINAL STEP T
I
1ST STEP TIME5
3RD TORQUE RATE LO3RD TORQUE RATE HIGH4
2ND TORQUE RATE LO2ND TORQUE RATE HIGH3
1ST TORQUE RATE LO
W
1ST TORQUE RATE HIGH2
FINAL ANGLEPEAK TORQUE1
DSP 2 OUTPUT
(AXIS UNIT)
DSP 1 OUTPUT
(AXIS UNIT)
DSP SWITCH
(MAIN UNIT)
AXIS UNIT DISPLAY TABLE (FASTENING RESULTS)
Fastening rejects are indicated by dual-color LED's on the affected spindle's Axis Unit, as
shown in the table below.
1ST STEP TIME O
V
2ND, 3RD, FINAL STEP
TIME OVER
TIME
LOW REJECTHIGH REJECT3RD RATE
LOW REJECTHIGH REJECT2ND RATE
LOW REJECTHIGH REJECT1ST RATE
LOW REJECTHIGH REJECTANGLE
LOW REJECTHIGH REJECTTORQUE
L.E.D. LIT TO ORA
N
L.E.D. LIT TO RED REJECT TYPE
AXIS UNIT REJECT DISPLAY TABLE
Chapter 3: System Description
Page 3-10