Chapter 2: Specifications Page 2-1
Chapter 2: Specifications 2.1 System Specifications w Power Supply Voltage P 200~230 VAC ±10%, 3-Phase, 50/60 Hz w Installation Requirement P NEMA 12 enclosure w Range of Operation P Duty cycle within 50% (reference Section 2.2 Duty Cycle Calculation) P Additional specifications will be provided for nutrunners greater than 50 kgm.
Chapter 2: Specifications 2.2 Duty Cycle Calculation The rated duty cycle for the AFC1200 System is calculated as follows: Tool Rotation Time Total Cycle Time (Tool Rotation + Tool Waiting) Example: Tool Rotation Time = Total Cycle Time = X 100 = Duty Cycle Percentage (%) 3 Seconds 12 Seconds x 100 = 25% Duty Cycle Percentage Duty cycle ratings vary between tools. As a general rule, however, it should not exceed 50%. Refer to the specifications for each tool.
Chapter 2: Specifications 2.
Chapter 2: Specifications 2.4 Axis Controller Unit Specifications AXIS UNIT TYPE TOOL MOTOR TYPE TOOL MOTOR MODEL NUMBER TOOL MOTOR RATING AXIS UNIT PEAK CURRENT AXIS UNIT IN-RUSH CURRENT AXIS UNIT INPUT POWER AXIS-203 M1 W1 AXIS-205 M2 M3 MFA006 BNE006- MFA010 MFA020 HA2NSA A117 HA2NSA HA2NSA AXIS-210 W3 M4 BXE020A912 MFA040 HA1NS 60W 70W 100W 200W 200W 400W .625A .
Chapter 2: Specifications 2.5 Nutrunner (Tool) Specifications w Fastening accuracy (Torque): From 1/4 ~ full scale torque: 6 (less than 10%) w Torque sample rate: Full Scale Torque x 1/1000 w Torque display resolution: 4.5 digit display with floating decimal point w Fastening accuracy (Angle): Within +1 degree w Angle sample rate: Below 0.036 degree (dependent upon gear ratio) w Angle display resolution: 0.
Chapter 2: Specifications DFT-401M2-S/O AXIS-203 39.2 4.0 400 28.8 346 19.8 :1 500 5 DFT-601M3-S/O AXIS-205 58.8 6.0 600 43.3 520 12.6:1 790 8 DFT-801M3-S/O AXIS-205 78.4 8.0 800 57.6 693 19.8 :1 500 5 DFT-132M3-S/O AXIS-205 127.4 13.0 1,300 94.0 1,127 25.2 :1 395 4 DFT-152M3-S/O AXIS-205 147.0 15.0 1,500 108.0 1,300 31.5:1 315 4 DFT-202M3-S/O AXIS-205 196.0 20.0 2,000 144.0 1,734 45.0 :1 220 3 DFT-302M3-S/O AXIS-205 294.0 30.0 3,000 216.
Chapter 2: Specifications 2.5.
Chapter 2: Specifications (BLANK PAGE) Page 2-9
