Chapter 2: Specifications Chapter 2: Specifications Page 2-1
Chapter 2: Specifications 2.1 System Specifications w Power Supply Voltage P 200 to 230 VAC ±10%, 3-phase, 50/60 Hz w Installation Requirement P NEMA 12 enclosure w Range of Operation P Duty cycle within 50% (reference Section 2.2: Duty Cycle Calculation.) P Additional specifications will be provided for nutrunners greater than 50 kgm.
Chapter 2: Specifications 2.2 Duty Cycle Calculation The rated duty cycle for the AFC1200 System is calculated as follows: Tool Rotation Time Total Cycle Time (Tool Rotation + Tool Waiting) X 100 = Duty Cycle Percentage (%) Example: Tool Rotation Time = 3 sec. Total Cycle Time =12 sec. Duty Cycle Percentage = 3 12 X 100 = 25% Duty cycle ratings vary between tools. As a general rule, however, it should not exceed 50%. Refer to the specifications for each tool.
Chapter 2: Specifications 2.3 ISA Main Controller Unit Specifications w CPU: 80486-DX4 32-Bit Microprocessor (486DX4, 100 MHz, IBM-Compatible) w KEYBOARD: Pendant Type, 20 Keys w MONITOR: Standard: VGA Interface Optional: Color Liquid Crystal Display (LCD) w DATA Communication: w PRINTER: RS232C Output CH1 RS422 Port (Option) DOT matrix RS232C Input CH2 Centronics Parallel Port COLOR GRAPHIC EPSON FX TYPE EPSON VP TYPE HP PAINTJET Epson Color w FLOPPY DISK Drive: FDD 3.5", 1.
Chapter 2: Specifications NOTE: Several ISA Main Controller Units may be linked together to provide a fastening capacity of more than 24 spindles.
Chapter 2: Specifications 2.4 Axis Controller Unit Specifications AXIS UNIT TYPE TOOL MOTOR TYPE TOOL MOTOR MODEL NUMBER TOOL MOTOR RATING AXIS UNIT PEAK CURRENT AXIS UNIT IN-RUSH CURRENT AXIS UNIT INPUT POWER AXIS-203 M1 W1 AXIS-205 M2 M3 W3 MFA006 BNE006- MFA010 MFA020 BXE020HA2NSA A117 HA2NSA HA2NSA A912 AXIS-210 M4 MFA040 HA1NS 60W 70W 100W 200W 200W 400W .625A .
Chapter 2: Specifications 2.5 Nutrunner (Tool) Specifications w Fastening accuracy (Torque): From one quarter (1/4) to full scale torque: 6 σ (less than 10%) w Torque sample rate: Full Scale Torque x 1/1000 w Torque display resolution: Four (4) digit display with floating decimal point w Fastening accuracy (Angle): Within one (1) degree w Angle sample rate: Below 0.036 degree (dependent upon gear ratio) w Angle display resolution: 0.
Chapter 2: Specifications 2.5.
Chapter 2: Specifications (BLANK PAGE) Page 2-9
