User guide


9.0 Alphabetical List of Abnormals
9-209.4.4Preset Data Abnormal
9-149.3.3Preset Spindle Does Not Exist
9-139.3.2Preamp EEPROM Read Abnormal
9-249.4.10Preamp EEPROM Read Abnormal (Axis Code "A3")
9-169.3.7Parameter Set Abnormal
9-199.4.3Offset Check Abnormal
9-109.2.6No Upload Error
9-119.2.9No Statistics Data
9-219.4.6Motor Over Temperature Abnormal
9-49.1.2Keyboard Failure
9-289.5.1Input Error
9-269.4.13Input Power Over Abnormal
9-239.4.9Full Scale Torque Over Abnormal
9-99.2.4Fastening
9-69.1.7Failure To Fasten
9-219.4.5Encoder Angle Pulse Abnormal
9-119.2.8EEPROM Write Error
9-259.4.12Dual Port RAM Abnormal
9-59.1.5DOS Boot Failure
9-289.5.2Data Error
9-59.1.4CRT Failure
9-149.3.4Controller EEPROM Write Abnormal
9-179.3.9Console Dual Port Ram Abnormal
9-49.1.1Communications I/F Abnormal
9-129.2.11Communication Time Over
9-89.2.1Command Error
9-49.1.3CMOS Power On Self-Test (POST) Failure
9-199.4.2Cal Check Abnormal
9-69.1.6Bad or Missing Command Interpreter
9-279.4.16Axis Unit Lockout
9-299.6Axis Unit Display Codes
PAGE #SECTION #MONITOR (CRT) DISPLAY "ABNORMAL"
MESSAGE
Chapter 9: Troubleshooting User Console Version A3.53
Page 9-2