Chapter 1: Outline Chapter 1: Outline Page 1-1
Chapter 1: Outline 1.1 Functions Outline w General The AFC1200 ISA Fastening System is a culmination of over twenty (20) years of electric fastening expertise integrated with the latest electronics technology.
Chapter 1: Outline specified in Sections 9.4.1 and 9.4.2, an Abnormal output will be generated and the fastening process will be interrupted. w Self-check Function The AFC1200 System is designed to perform several self-checks. Each time the system is powered on, it completes a Power On Self-Test (POST) to verify the compatibility and connection of all equipment. Refer to Chapter 9 -Troubleshootingfor details of all system self-checks.
Chapter 1: Outline 1.2 System requirements To ensure the most effective and extended use of all equipment, adhere to the following specifications: w Tool Installation Tools generate a great amount of torque during operation, and the reaction force is applied to the mounting area of the tool. Therefore, tools must be installed in the proper positions and with adequate bolts. Use the specified bolts to prevent the tool from loosening due to vibration.
Chapter 1: Outline P Controller Units must be located a minimum of 600 mm from sources of high transient voltage such as transformers, AC inverters, AC contactors and motor starters. If this cannot be avoided, then the units must be properly shielded. w Static Electricity AFC1200 System construction incorporates many electronic Surface Mounted Devices (SMD). It is advisable to strictly adhere to practices for safe electrostatic discharge in order to prevent damage to the system.
Chapter 1: Outline 1.3 About this Software The software installed for the AFC-1200 User Console requires compatible software versions installed in both the Multi Board (mounted into the Main Unit) and the Axis Unit. The following table shows the software compatibility for this User Console version: User Console Software Version Multi Board Software Version Axis Unit Software Version A5.06 F4.06 D4.03 Should you need further information, please contact FEC, Inc.
