User guide


FIG. 7-9-2-2 system configuration (2) upper half, screen explanation
2-3. RS232C PORT (CH1) [SYSTEM CONFIGURATION (3)]
FASTENING DATA PRINT OUT : NO (YES)
the print out of fastening data may be enabled or disabled via this function.
DATA SELECT : ALL (ACCEPT, REJECT, ACCEPT & REJECT)
specific fastening data types may be printed out by setting this delimiter.
HEADER PRINT OUT MODE : NO PRINT OUT (POWER ON, FORM FEED,
FASTENING PRINT OUT)
The header may be printed out for any of the selection options.
FORM FEED : NO (YES)
Form feed at the end of each page is enabled or disabled by this command.
PAGE PRINT OUT : NO (YES)
Page numbering at the top of each page is enabled or disabled by this command.
BAUD RATE : 1200 BPS (2400, 4800, 9600, 19200)
the communications baud rate for this port may be set to one of five common values.
CHARACTER : 7 BIT (8 BIT)
Character length may be set to either seven or eight bits.
PARITY : EVEN (ODD, NO PARITY)
parity may be set to odd, even, or no parity.
Chapter 7: System Operation
Page 7-61