User guide


7.3.4 Vocabulary List [Fastening Data]
PEAK TORQUE Highest torque value measured during fastening.
OFFSET TORQUE Prevailing torque value measured during Offset Check
(Check must be enabled via sequence or external input).
FINAL TORQUE Final torque value measured upon completion of fastening.
FINAL ANGLE Final angle value measured upon completion of fastening
(measured from snug torque).
ELONGATION ANGLE Angle value measured from the detected yield point to
completion of fastening.
ELONGATION LENGTH Calculated amount of permanent elongation of the fastener.
1ST TORQUE RATE Highest 1st Torque Rate value when using the Integrated
HIGH Torque Rate calculation method. Average 1st Torque Rate
value when using the Point-to-Point calculation method.
1ST TORQUE RATE Lowest 1st Torque Rate value when using the Integrated
LOW Torque Rate calculation method. Not utilized when using
the Point-to-Point calculation method.
2ND TORQUE RATE Highest 2nd Torque Rate value when using the Integrated
HIGH Torque Rate calculation method. Average 2nd Torque Rate
value when using the Point-to-Point calculation method.
2ND TORQUE RATE Lowest 2nd Torque Rate value when using the Integrated
LOW Torque Rate calculation method. Not utilized when using
the Point-to-Point calculation method.
3RD TORQUE RATE Highest 3rd Torque Rate value when using the Integrated
HIGH Torque Rate calculation method. Average 3rd Torque Rate
value when using the Point-to-Point calculation method.
3RD TORQUE RATE Lowest 3rd Torque Rate value when using the Integrated
LOW Torque Rate calculation method. Not utilized when using
the Point-to-Point calculation method.
1ST RATE INC TORQUE Change in torque as measured from Threshold 1 torque until
1st Torque/Angle
1ST RATE INC ANGLE Change in angle as measured from Threshold1 torque until
1st Torque/Angle
2ND RATE INC TORQUE Change in torque as measured from 1st Torque/Angle until
Crossover Rate 2 Torque/Angle
2ND RATE INC ANGLE Change in angle as measured from 1st Torque/Angle until
Crossover Rate 2 Torque/Angle
3RD RATE INC TORQUE Change in torque as measured from Crossover Rate 2
Torque/Angle until completion of fastening.
3RD RATE INC ANGLE Change in angle as measured from Crossover Rate 2
Torque/Angle until completion of fastening.
Chapter 7: System Operation
Page 7-33