User guide


1ST TORQUE SEat torque (1st Torque), end of 1st TORQUE RATE
measurement, start of 2nd TORQUE Rate measurement
NOTE: EITher 1st tORQUE or 1st angle may set, but not both.
1ST ANGLE Seat angle (1st angle), end of 1st TORQUE RATE
measurement, start of 2nd TORQUE RATe measurement
CROSSOVER RATE 2 End of 2nd tORQUE Rate measurement, start of 3rd
ANGLE TORQUE RAte measurement
2ND ANGLE Angle for 2nd Step in multi-step fastening
3RD ANGLE Angle for 3rd Step in multi-step fastening
FINAL ANGLE FINal target angle in ANGLE CONTROL Mode, end of 3rd
TORQUE Rate measurement
HIGH TORQUE HIGh torque limit
LOW TORQUE lOw torque limit
HIGH ANGLE High final angle limit
LOW ANGLE LOw final angle limit
INCREMENT ANGLE PREset angle for INTEGRATED TORQUE RATe
1ST TORQUE RATE HIGH HIgh limit for 1st TORQUE RAte
1ST TORQUE RATE LOW LOw limit for 1st TORQUE RATe
2ND TORQUE RATE HIGH HIGH limit for 2nd TORQUE RAte
2ND TORQUE RATE LOW LOw limit for 2nd TORQUE RAte
3RD TORQUE RATE HIGH HIgh limit for 3rd TORQUE RATE
3RD TORQUE RATE LOW LOw limit for 3rd TORQUE RATe
Chapter 7: System Operation
Page 7-20