User guide


6.2 High Speed Set-Up
w High Speed switches are used to
select the high speed setting.
w Verify power is off, or bypass mode
has been selected and In Bypass
switch is lit, prior to changing the
setting of the High Speed switches.
w Do not change this set-up while the
tool is running because it may result in
operation errors or accidents.
w Refer to the following table for speed
set-up.
Fig. 6.2
150 rpm112 rpm75 rpm 37 rpmDRT-302M3-S/O
220 rpm165 rpm110 rpm 55 rpmDRT-202M3-S/O
315 rpm235 rpm157 rpm78 rpmDRT-152M3-S
395 rpm296 rpm197 rpm 98 rpmDRT-132M3-S/O
500 rpm375 rpm250 rpm125 rpmDRT-801M3-S/O
speed may vary slightly.790 rpm593 rpm395 rpm197 rpmDRT-601M3-S
are approximate. Actual500 rpm375 rpm250 rpm125 rpmDRT-401M2-S/O
The speeds given in the table250 rpm187 rpm125 rpm 62 rpmDRT-401M1-S/O
790 rpm593 rpm395 rpm197 rpmDRT-201M2-S
500 rpm375 rpm250 rpm125 rpmDRT-201M1-S/O
500 rpm375 rpm250 rpm125 rpmDRT-101M1-S1/O1
1100 rpm825 rpm550 rpm275 rpmDRT-101M1-S/O
1234
SWITCHSELECTEDTOOL TYPE
NOTE: Select only one speed. Verify that only one switch is set to the "on" position.
CHAPTER 6: PRE-SETS AND OPERATION
Page 6 - 5
SLOW START SPEED
SELECT SWITCHES