User guide


Time reject dual color LED indicator. Refer to Axis unit
Reject Display Table following.
TIME15
2nd Rate reject dual color LED indicator. Refer to Axis unit
Reject Display Table following.
2ND RATE14
1st Rate reject dual color LED indicator. Refer to Axis unit
Reject Display Table following.
1ST RATE13
Angle reject dual color LED indicator. Refer to Axis unit
Reject Display Table following.
ANGLE12
Torque reject dual color LED indicator. Refer to Axis unit
Reject Display Table following.
TORQUE11
Display LED (red) that indicates some component of the
spindle (Axis unit, nutrunner, etc.) is in an Abnormal state,
and the fastening cycle has been interrupted. A failed Cal
Check or Zero Check will also display as an ABNORMAL.
ABNORMAL10
Display LED (red) that indicates when the Axis unit is in the
Bypass mode. Spindle will not operate in this mode.
BYPASS 9
Display LED (green) that indicates the spindle has
completed an acceptable fastening, Zero Check, or Cal
Check.
ACCEPT 8
Display LED (yellow) that indicates when the Axis unit is
operating.
BUSY7
Two-digit display who's function is dependent upon the
D-NO selected. When configured to display spindle
number (SPNO) this number is set by dip switch settings
(reference Section 4.10.2 ).
ANG/SPNO6
Four digit display who's function is dependent upon the
D-NO selected
DATA5
RED LED that indicates that the "PARM/ABN" display is
currently displaying an Abnormal code #
ABN4
Green LED that indicates that the "PARM/ABN" display is
currently displaying the Parameter #
PARM3
Displays one-digit Parameter number and, as needed, will
override Parameter output to display an Abnormal code.
Refer to Chapter 9 for Abnormal display code descriptions.
PARM/ABN2
Display number that indicates what the data in the "DATA"
and "ANG/SPNO" display represents.
D-NO1
DESCRIPTION (REFERENCE FIGURE 3-2-2) ITEM AS MARKED ON UNIT
Fastening rejects are indicated by dual-color LED's on the affected spindle's Axis unit, as
shown in the table below.
1st STEP TIME O
V
FINAL STEP TIME OVERTIME
LOW REJECTHIGH REJECT2ND RATE
LOW REJECTHIGH REJECT1ST RATE
LOW REJECTHIGH REJECTANGLE
LOW REJECTHIGH REJECTTORQUE
L.E.D. LIT TO ORA
N
L.E.D. LIT TO RED REJECT TYPE
AXIS UNIT REJECT DISPLAY TABLE
Chapter 3: System Description (Rev. 8/98)
Page 3-7