User guide


Supply power for Axis unit (200~230 VAC, 3 Phases).AC-IN 200~230V17
Connector for the nutrunner (tool) motor (M).MOTOR 16
Connector for the nutrunner (tool) encoder (ENC).ENCODER 15
Interface connector for System input/output control lines.
Refer to Chapter 4 for detailed input and output descriptions.
AXIS I/O14
Torque analog voltage and angle pulse output.TQ/ANG OUT13
Connector for the tool torque transducer/preamplifier (PA).T/D 12
Axis unit Enable / Disable switchRUN/BYPASS 11
Bidirectional RS422 Communications portRS422 OUT 10
Bidirectional RS422 Communications portRS422 IN9
Data change decrease pushbutton.
↓
↓↓
↓
- Down8
Data change increase pushbutton.
↑
↑↑
↑
- Up7
Data change confirmation pushbutton.SET 6
Display mode selection pushbutton. Refer to Chapter 7. MODE 5
Manual Zero Check and System reset pushbutton.(MANUAL) RESET4
Manual Calibration (Cal) Check pushbutton.(MANUAL) CAL3
Manual reverse pushbutton.(MANUAL) REV2
Manual fastening start pushbutton. (MANUAL) START1
DescriptionItem as called out on Figure 3.2.1
Chapter 3: System Description (Rev. 8/98)
Page 3-5