User's Manual

5
FDT Technologies-http://www.fdt.us
All the examination and repair work should be done by qualified service engineers.
We are not liable for any problems caused by unauthorized modifications or
user-attempted repair.
Environment
The camera should be kept in a cool, dry place away from direct sunlight, flammable
materials, explosive substances, etc.
This product should be transported, stored, and used only in the specified environments
as stated above.
Do not aim the camera at a strong light source, as it may cause overexposure of the
picture, and may affect the longevity of the camera’s sensors.
Ensure that the camera is in a well ventilated area to prevent overheating.
Operation and Maintenance
Do not touch the camera sensor or lens directly.
To clean dust or dirt off of the lens, use an air blower or a microfiber cloth.
Accessories
Be sure to use only the accessories recommended by manufacturer.
Before installation, please open the package and check to ensure that all of the
components are present.
Contact the retailer that you purchased from, or FDT directly if anything is broken or
missing in the package.
Check Hardware
When you receive the product in the package, unpack it and check all sides of the product
for any physical damage. The protective materials used in the package of the product can
protect most accidental damage during transportation, but to ensure your equipment is
operating as expected, it is recommended to inspect the product before proceeding
further.
On the product, check specifically that the label on the bottom of the product is not
damaged. The serial number of the unit is often needed to provide support.
Please check that all required items for your camera are present. If any item is missing,
please contact us as soon as possible so we can send you the missing component.
Note: Hardware may not look exactly as pictured in this section, but the steps to assemble
the hardware are the same.
Hardware Installation
Note: Prior to installation, ensure that the installation environment can support at least 3
times the weight of the camera. And do not place objects on top of the camera.