Datasheet

Connection Terminal Specifications for Lithium Batteries and Key Circuit Design Points
When choosing batteries, the rating of the device, operating load conditions, and operating temperature range should be considered.
Also, when deciding connection terminal configuration, battery installation space and battery fixation method should be considered.
Refer to the lithium battery section of the battery selection guide (p12).
When planning circuit design, please keep in mind that there is a large difference between primary and rechargeable lithium batteries.
The properties of each design must be completely understood before implementation.
Please consult SANYO for further details or inquiries.
SANYO standard configuration and model No. display methods are as shown below.
Standard SANYO specifications are given starting on page 1.
■
■■
■ Tab specification
Battery model No. Attachment method Tab configuration
○ Attachment method (to a PC board)
H : Horizontal attachment
V : Vertical attachment
T : Surface mount attachment
Z : Special attachment
△ Tab configuration
T : Flat board (width 3mm)
I : Flat board (top width; 0.5〜1.9mm)
H : Flat board with hole (top width; 3.0〜3.9mm)
L : Flat board with hole (top width; over 4mm)）
J : Top J type
M : Top pin type
R : 3 terminal type (corner R ant)
S : 3 terminal type (corner R pear)
Z : Special
HR type
HJ type
VS type TT type
■
■■
■ Lead wire specification
Battery model No. Lead wire specification
L type
■
■■
■ Connector specification
L
C
C type
Battery model No. Connector specification