Product Manual
Table Of Contents
- CHAPTER I PRODUCT INTRODUCTION
- 1.1 INTRODUCTION
- 1.2 F7S HOST STRUCTURE
- 1.3 VCI BOX STRUCTURE
- CHAPTER II HOST ON/OFF AND FUNCTION MENU
- 2.1 HOST CHARGING
- 2.2 BOOTING
- 2.3 SHUTDOWN
- 2.4 INTRODUCTION TO EACH MENU OPTION
- CHAPTER III VEHICLE DIAGNOSIS
- 3.1 PRE-DIAGNOSTIC TECHNICAL REQUIREMENTS
- 3.2 VEHICLE CONNECTION
- 3.3 VEHICLE TYPE SELECTION
- 3.4 DIAGNOSIS AND OTHER HIGH-LEVEL FUNCTION
- 3.5 DIAGNOSIS
- 3.6 SPECIAL FUNCTION
- 3.7 GENERAL OBDII (FOR GASOLINE MODELS)
- 3.8 DEMO ON THE FCAR F7S AND DIAGNOSTIC SOCKET CON
- CHAPTER IV DATA MANAGEMENT
- CHAPTER V REMOTE DIAGNOSIS
- CHAPTER VI REFERENCE
- CHAPTER VII UPDATE
- CHAPTER VIII SETTINGS
- CHAPTER Ⅸ COMPLIANCE INFORMATION
- WARRANTY CLAUSES
FCAR Product Manual
3
Before starting the engine, apply the handbrake and place the shift lever in Gear
Neutral (Manual Transmission) or P (Automatic Transmission) to avoid sudden
movements of the vehicle when starting the engine.
Before repairing the vehicle, apply the parking brake, engage the Neutral or P range,
and lower the driver seat’s glass doors.
If the engine can be started, warm-up the vehicle to normal temperature (water
temperature is about 80 °C), and turn off the auxiliary electrical appliances (such as
air conditioning, lighting, sound, etc.).
Find the diagnostic socket of this car; check and confirm the diagnostic socket
cables are in good condition, connecting the main unit for diagnosis. Otherwise, do
not test, to avoid damage to the main unit. If necessary, use a multimeter to
measure the voltage of the diagnostic socket.
Instrument Use Notes
When using FCAR series products for testing, please be gentle and keep them away
from heat and electromagnetic fields, to avoid interference to the main unit.
Do not use sharp tools to click the screen; the matched touch pen is recommended.
When electrical components are energized, do not disconnect the circuit, to prevent
self-inductance and mutual inductance current damaging the sensors and
automotive ECU.
When electrical components are working normally, magnetic objects are forbidden
to approach the automotive control unit, otherwise the vehicle control unit may be
damaged.
Before disassembling the vehicle control unit or electrical components, turn off the
ignition switch for 1 minute.
Do not operate the diagnostic equipment when driving the vehicle, in order to avoid
traffic accident.