Product Manual
Table Of Contents
- CHAPTER I PRODUCT INTRODUCTION
- 1.1 INTRODUCTION
- 1.2 F7S HOST STRUCTURE
- 1.3 VCI BOX STRUCTURE
- CHAPTER II HOST ON/OFF AND FUNCTION MENU
- 2.1 HOST CHARGING
- 2.2 BOOTING
- 2.3 SHUTDOWN
- 2.4 INTRODUCTION TO EACH MENU OPTION
- CHAPTER III VEHICLE DIAGNOSIS
- 3.1 PRE-DIAGNOSTIC TECHNICAL REQUIREMENTS
- 3.2 VEHICLE CONNECTION
- 3.3 VEHICLE TYPE SELECTION
- 3.4 DIAGNOSIS AND OTHER HIGH-LEVEL FUNCTION
- 3.5 DIAGNOSIS
- 3.6 SPECIAL FUNCTION
- 3.7 GENERAL OBDII (FOR GASOLINE MODELS)
- 3.8 DEMO ON THE FCAR F7S AND DIAGNOSTIC SOCKET CON
- CHAPTER IV DATA MANAGEMENT
- CHAPTER V REMOTE DIAGNOSIS
- CHAPTER VI REFERENCE
- CHAPTER VII UPDATE
- CHAPTER VIII SETTINGS
- CHAPTER Ⅸ COMPLIANCE INFORMATION
- WARRANTY CLAUSES
FCAR Product Manual
27
Actuation test: Carry out the module testing of specific subsystem
3.5.1 READ FAULT CODE
Read and display the fault code retrieved from the vehicle system module under test and
explain the fault content, as shown in Figure 3.5.1:
Figure 3.5.1 Read Fault Code
3.5.2 ERASE FAULT CODE
Before clearing the fault code for later viewing and comparison, please record and store
the read fault code that you read.
How to erase fault code
1) Select [Erase fault code] on the control module diagnosis interface;
2) At this time, the diagnostic system will pop up the prompts “Turn off the engine and
turn on the ignition switch”, “The fault code and freeze frame data will be cleared,
do you want to continue?”, select [Continue]; (Note: This step requires you to
strictly operate the vehicle in accordance with the menu prompts)
3) When another prompt message pops up, select [Return] and re-execute the read fault
code function to verify whether the fault code has been cleared.