User Manual

S
t
a
e
1
2
M
a
14
UK
CONTROLS AND FUNCTIONS
O
1
2
3
4
ON
PK
PRT / LMT
+6
dB
0
0
0
PRESET
LEVEL
LINK
IN
PRESET CHART
1
ORIGINAL
2
VOCAL
3
HI-END
4
FOH
HP FIL
TER
OFF
ON
P. C. : 450VA
220-230V
50 / 60Hz
T2.5A
L
250V
(
(
MADE IN
ITALY
St
a
g
e
12Ma
Processed Active Monitor
ON
Indicates that the system in on.
PK
When this led lights up it indicates that the signal is reaching saturation. Adjust signal level until the led turns off and
stays off.
PRT / LMT
If this led lights up, there is a system malfunction due to an internal amplifier failure or to the intervention of current
limiting circuits against thermal overload. The occasional led lighting up during highest signal peaks does not imply
any troubles in system proper operation; if the led stays on, lower the signal; if the led stays on even without any
signal, the system is in safe mode; then, switch the system off, wait approximately for 1 minute and switch it on
again.
HP FILTER
This switch activates the low-cut filter, which lets only the frequencies above the cut-off frequency pass at the
output.
IN - LINK
Balanced input/output XLR sockets; «IN» allows for the connection of a pre-amplified signal, such as, for
instance, the signal coming from mixer output. «LINK» allows for the connection of multiple speakers to the
same signal.
LEVEL
It adjusts signal general level.
PRESET
It is used to select 4 presets, each one corresponding to a different equalization according to the personal
preferences and to the acoustics of the environment; the existence of presets controlled by the DSP allows to
change speaker response much more accurately compared to the tone controls; moreover, the presets are already
designed and optimized in anechoic chamber in order to provide the speaker precisely with the desired
characteristics:
ORIGINAL: the unique «MaxX» sound; default preset suitable for use on stage.
VOCAL: it allows for the best speech intelligibility even in difficult environments or with high noise floors; the
passband is modified for emphasizing the vocal range.
HI-END: it is characterised by the typical response of top range speakers, exclusively designed for touring;
therefore it provides excellent linear response and passband without excessive extension on the boundaries.
FOH: preset for «front of house» use in stand or flying installations.