User's Manual

WEMS Installer’s Guide 21

WEMS Software

Configuration Menus

Luna iMonitoring preconfigures the settings for all its devices. To view the

current settings or to reconfigure the device, select the device in the main menu

and hit the Configure button to bring up one of the menus shown in Figure 14.

Menu (a) shows the sensor configuration menu for an iWPM-T, but other sensor

configuration menus contain the same information and options. The sensor

menu includes the serial number for the iCCU to which the sensor uplinks. If the

CCU field contains all zeros, as in Figure 14, then the sensor broadcasts to all

listening iCCUs. Menu (b) shows an iCCU configuration menu which does not

include the CCU field.

(a)

(b)

Figure 14. Configuration Menus for an (a)

CCU, and an (b)

WPM-T.

To change a parameter value, first highlight the value with a single tap, then

enable the value for editing with another tap. Now select the keyboard entry

screen by tapping the keyboard icon at the bottom right of the screen. Use the

keyboard to enter the new value. When finished entering the data, exit the

keyboard by tapping the icon again. DO NOT USE THE “ENTER” KEY, as this will

cause the application to exit. Once all the new parameter values are entered, hit

the Set Parameters button to accept the changes. Parameters shown in