User's Manual

WEMS Installer’s Guide 16
WEMS Software
Adding New Devices
Every Luna iMonitoring device has a unique serial number found on the Luna
iMonitoring Serial Number label attached to the device. The software identifies
each device by its unique serial number. The sensor list contains the serial
numbers of the last ten devices accessed by the software. To add a device to
the sensor list, enter the unique serial number of the device in the space
provided and hit the “<” button. If the sensor list already contains ten serial
numbers as in Figure 9 below, then the least recently accessed device drops
from the sensor list. To interrogate a sensor already in the list, simply select the
proper serial number from the list and hit the “>” button to copy the serial
number into the Serial Number field. To access a sensor not in the list, type its
serial number in the space provided. The software automatically adds the serial
number to the list when the Configure button is selected. To clear the selected
sensor from the sensor list, hit the Clear button.
Figure 9. PocketConfig Main Menu.