User's Manual

WEMS Installer’s Guide 12
WEMS Software
Chapter 3
WEMS Software
The WEMS Software is a multi-purpose, menu-driven program for configuring
and accessing all modules in Luna iMonitoring’s Intelligent Wireless Sensor Suite.
Once properly configured using the WEMS Software, the devices run
autonomously based on the scheduling parameters set in the software. The
WEMS Software also provides in-the-field access to any device. The following
sections include procedures for initializing all WEMS modules, and instructions for
interrogating these devices in the field.
Installing the WEMS Software
(a) (b)
Figure 5. (a) SD Card; (b)
i CFR
The WEMS Software runs on a PocketPC
®
using the SD Card provided by Luna
iMonitoring. The PocketPC
®
communicates with the sensors and iCCUs using the
iCFR also provided by Luna iMonitoring. The user supplies the PocketPC
®
, which
must contain a CF slot and SD slot, and must run PocketPC
®
Version 3.0 or
higher. Follow the steps below to install and initialize the WEMS Software.
1) Insert the iCFR into the CF slot on the PocketPC
®
.