Manual

4 – Appendices NET SatisFAXtion 8.7 Manual 214
that it supports, but are unreliable in your environment or are undesirable for
some other reason. On transmitting, use this as a mask; the modem will use
only those rates you list. On receiving, set the fastest and slowest rates; the
modem will allow those and any in between. Format: Comma separated list of
14400, 12000, 9600, 7200, 4800 and 2400. Default:
14400,12000,9600,7200,4800,2400.
carrier_wait [dword 0–255]: Seconds the driver to wait in the “dialing” or “an-
swering” states for a carrier from the remote device before hanging up. De-
fault: 45.
dial_wait [dword 0–255]: Seconds the driver to wait in the "ringing" state be-
fore hanging up. Default: 45.
flow_control [string]: Designates the type of flow control to use when send-
ing data. If the setting is XON_XOFF the driver observes XOFF signals when
sending. The driver uses no flow control when receiving. Format: Either
XON_XOFF or RTS_LEVEL. Default: RTS_LEVEL.
rings_before_answer [dword 0–255]: Number of rings before modem ac-
cepts call. Default: 1.
ser_device_name [string]: Win32 name for the serial port in the format of
COMXXX where XXX can be 001–999. This does not need to be specified if
the tapi_modem_name is specified. Format: Up to 6 characters.
init_string [string]: This is the basic modem initialization string. It should reset
the modem and init the required flow control. Format: Up to 80 characters.
Default: &F&C1&D2V1E0S0=0S7=90^^.
All modem commands start with AT, so this string does not need AT. The sym-
bols in the string mean the following:
^ 2-second pause
\ Carriage return. There is a wait of
init_string_timeout_msecs after carriage return to wait an OK to
be returned.
\\ Specifies a single \
^^\ this is interpreted as \^^
init_string_timeout_msecs [dword 0–65535]: How long to wait for re-
sponse after CR in the init_string if there are no 2-second pauses before or
after the CR. Default: 5000.
io_buffer_size [dword 0–65535]: This is the size of the image buffer. The
necessary buffer size depends on host CPU speed and load as well as connect
speed. This buffer directly adds to driver page locked memory use so should be
as small as possible. However, too small a buffer will cause faxes to fail. De-
fault: 20480.
show_console_scroll_back_buffer_size [dword 0–4294967295]: When
the debug output is CONSOLE, this is how big of a buffer to be used for scroll-
back. Default: 282144.