Owner manual

FAWCETT CO, INC. HDPM-5 manual 01/09 Page 4

Operation:
Caution:
• Never run mixer without an impeller.
• Never run the impeller in open air, outside container.
• Variable Speed Models: Always stop and start the
mixer in the lowest variable speed setting.
Electronic Speed Control: Hydraulic Jack Operation:
DC Variable speed models
Lifting:
*Turn control knob to zero, fully Counter-Clockwise. *Insert the handle onto the release valve
*Turn power switch on and slowly advance control knob and turn clockwise until the valve is firmly closed.
clockwise while observing impeller shaft to check for *Place handle into jack handle sleeve
satisfactory operation throughout the speed range. “receptacle".
*Turn control knob to zero, fully Counter-Clockwise, turn * Actuate the jack handle up and down to raise
the power switch off. impeller to the desired height.
Lowering:
* Insert the handle onto the release valve and
slowly turn the handle counter-clockwise.
NOTE: Always start and stop your mixer in the slowest
speed setting