User Manual

1FAWCETT, Inc. LS manual 03/06 Page 5 of 7
LUBRICATED AIR MOTORS
OPERATION & MAINTENANCE
IMPORTANT: PLEASE READ THIS MANUAL AND
SAVE FOR FUTURE REFERENCE.
Thank you for purchasing this F awcett product. It is
manufactured to the highest standards using quality materials.
Please follow all recommend ed maintenance, operational and
safety instructions and you will receive years of trouble free
service.
Product Use Criteria:
• Operate at temperature up to 250ºF (121ºC).
• Protect unit from dirt and moisture.
• Use ONLY compressed air to drive motor.
• Air lines connected to motor should be the same size or the
next size larger than the intak e port for efficient outp ut and
speed control.
• Protect all surrounding items from exhaust air.
• Bearings are grease packed.
• Use #AD220 or a detergent SAE#10 automotive engine oil
for lubricating.
General information
• Clearances: Model Total End Clearance (in/mm) Top
Clearance (in/mm)
LS101 0.0020/0.050 8 0.0015/0.0381
LS102 0.0025/0.063 5 0.0015/0.0381
LS103 0.0035/0.088 9 0.0015/0.0381
LS104 0.0035/0.088 9 0.0015/0.0381
LS105 0.0048/0.121 9 0.0015/0.0381
• Vane Life: Depends upon speed, operating pressur e an d
motor maintenance.
• Operating Pressure: 100 psi or below (7 bar)
Correct installation is your responsibility. Make sure you
have the proper installation co nditions and that the specified
installation clearances are av ailable.
INSTALLATION
Connection
Check the direction of the motor airflow. A single rotatio n motor
will operate properly only in one direction. Install a filter in the
air line before the connection to the motor. Conn ect lines to
motor in the proper direction. A reversible motor will work
equally well in both directio ns. Connecting a 4-way valve with
piping to both air ports of the motor will make reversing
possible.
Do not add any thrust to the end or side of the shaft when
making connections. Do not use a hammer on the shaft or
connections.
Mounting
This product can be installed in an y orientation. Mount the
motor to a solid base plate that is mounted to a stable, rigid
operating surface. Install a pressure regulator or simple shut-
off valve to control motor.
Consult your Fawcett Co. representative for additional filter
recommendations. Install a moisture trap and filter in the ai r
line ahead of the motor. For the most efficient output and
control of speed, use air lines that are the same size or the
next pipe size larger than the motor intake port. An
automatic air line lubricator should b e installed 18” or as
close as possible in the air line just ahead of the motor.
Adjust the lubricator to feed one drop of oil for every 50-75
CFM of air moving through the motor. Air consumption at
various speeds and pressures are available from your local
Fawcett representative.
It is your responsibility to operate this product at
recommended speeds, loads and room ambient
temperatures. Do not run the motor at high speed s with
no load. Th is will result i n excessive internal heat that
may cause motor damage.
The starting torque is less than the running torque. The
starting torque will vary depending upon the position of the
vanes when stopped in relation to the air intake port. Use a
pressure regulator and/or simple shut-off valve to regulate
the motor’s speed and torque. This will provide the required
power and will conserve air.
OPERATION
Injury Hazard
Air stream from product may contain solid or liquid
material that can result in eye or skin damage. Do No t
use combustible gases to drive this motor. Wear hearing
protection. Sound level from motor may exceed 85db(A).
Failure to follow these instructio n s can result in burns,
eye injury or other serious injury.
Air Power:
Check to ensure the air valve is in the closed position, then
connect air supply. Check rotation to be sure the mixer shaft
is rotating in a clockwise direction, looking downward into the
container.
Once the mixer is in the container, it is no w safe to operate.
CAUTION:
• Never run mixer without an Impeller.
• Never run the impeller in open air.
• Never run impeller outsid e a container.