User Manual
22
FastwayTrailer.com
conguration. With use, the spacer washers and rivet may compact slightly
leaving a small gap between the angle set bolt and the shank. e bolt should
be checked frequently when your hitch is new and re-tightened until it comes
in contact with the shank, plus 1/4 turn. You will notice that over time the
need to re-tighten the angle set bolt will diminish, but you should still check it
regularly before each towing day as part of your hook-up routine.
Store your hitch out of the weather when not in use. Keep it clean and free
from rust. From time to time, use a good quality rust inhibiting spray paint to
touch up the nish and keep it looking good. Do not paint over the warning
stickers. If the warning stickers become worn or unreadable, contact Progress
Mfg. Inc. for free replacements.
Noise:
Towing noise is often an indication that your hitch needs to be cleaned and/
or lubricated. Clean and grease your hitch as recommended. Following this
process should eliminate most of the noise coming from the hitch.
If after lubricating the hitch you still experience some noise do not be
alarmed. is is generally caused by the friction between the spring arms and
L-brackets, which means that your e2 hitch is working as it should to help
control sway.
Customer Support:
For customer support, replacement parts, and accessories we recommend
that you visit your local dealership that is familiar with Fastway® e2 products
whenever possible. If at any time you need customer support and are unable
to reach a dealership, please call our toll free customer support line at
877-523-9103, or visit us online at FastwayTrailer.com.