User Manual
16
FastwayTrailer.com
With the spring arms resting on the L-bracket and the trailer and tow vehicle
in line with each other, check to make sure that there is a minimum of 3” from
the end of the spring arms to the center of the link plates. See Figure 15. Move
and re-tighten the link plates if necessary.
NOTE: Refer to Appendix B “Weight Dis-
tribution Adjustments” on page 24 for a more
detailed description of factors that inuence
weight distribution setup and adjustment.
Retract the tongue jack until all of the tongue
weight is resting on the hitch. With the trailer
coupled and weight distribution engaged, re-
measure the front wheel well height from the
ground in exactly the same place as before in this
step. Record this new measurement on Line C of the Weight Distribution Setup
Table on page 15.
3”
minimum
Figure 15
Figure 13
Figure 14a
Figure 14b