Product Manual

1
2
3
4
5
6
CUT PIPE TO LENGTH with
tubing cutter (cut must be square)
(DO NOT USE HACK SAW)
DEBURR the end of the pipe
outside and inside
(a smooth edge allows easy
tting assembly and no damage
to the tting 0-ring)
MARK END OF PIPE
for the proper insertion depth
3/4” Fittings: 2 inches
1” Fittings: 2-3/4 inches
1½” Fittings: 4 inches
2” Fittings: 4-3/4 inches
WET END OF PIPE with
very diluted soapy water
DO NOT USE ANY OIL
OR GREASE LUBRICANT
LOOSEN FITTING CONE NUT
PARTIALLY
LOOK INSIDE EACH FITTING FOR INNER PARTS
(inner parts, o-ring, stainless steel bite ring)
INSERT PIPE into tting until
pipe bottoms out
HAND TIGHTEN tting
FULLY TIGHTEN tting with
FASTPIPE spanner wrenches
INSTALLATION
SADDLE DROP INSTALLATION
OUTLETS
WALL OUTLET
WALL OUTLET WITH SHUTOFF
Outlet ports are 1/2” Female NPT, Drain port is 3/8” Female NPT
QUICK COUPLER
-System must be de-pressurized before installing
-To prevent chips from entering the pipe interior, stop drilling occasionally and blow out chips, grease the end of the drilling tool
1) Position saddle drop opposite the side of the pipe that needs the hole
Tighten securely and mark the pipe by the raised locating mark on the tting
Mark the pipe both horizontally and vertically along the tting edge
2) Drill thru one side of pipe with the drill bit, using the hole in the tting as a locator
3) Insert the saddle drop gasket into the molded cavity
4) Position the saddle drop over the drilled hole with aligning marks, tighten securely
5) Attach the necessary drop pipe or threaded adapter
DRILL BIT
1”

2”
F2210C
F4210C
F5210C
9/16” F0043
3/4” F0044
3/4” F0044
GASKET
MAIN
SIZE
K7241 1/2” Male NPT Thread
Use a pipe thread bushing 1/2” Male NPT x 1/4” Female NPT to adapt standard 1/4” quick couplers
Or use a Rapidair K7241 1/2” Male NPT Quick Coupler
#50716
3/4” - 2”
*Tension O-ring on 3/4” and 1” ttings only
TAB MUST ALIGN TO NOTCH