Operation Manual

9.12. Printer paper change

The FMD55 has a thermal printer, paper width: 112mm. The

diameter of the paper roll must not exceed 45mm and the diameter of

the core, no more than 12.5mm. The standard supplied roll has an

approximate length of 25 metres and prior to reaching the end, a

colour indication will appear, reminding you to change the roll.

Changing the roll:

1. Switch the unit off

2. Remove paper roll lid (2 thumb screws).

3. Lift the pressure lever (90° to the casing)

4. Pull the old roll and core rod upwards to remove, making sure that

there are no paper remains left in the mechanism!

5. Stick the core rod through the new roll and replace in the holder.

6. Cut the end of the paper roll as in sketch

7. Feed the paper through the guide until the paper appears at the

tear-off blade.

Straighten the paper by pulling parallel.

8. Pull the paper at both ends so that it is parallel.

9. Replace pressure lever.

10. Replace the lid.

11. Switch unit on and make a print out (stored message) to see if the

printer is working properly.