Operation Manual

All the system parameters will now be printed out in an orderly

list.

The NAVTEX parameters must be printed out separately in the

NAVTEX menu (see Ch. 5.8.)

Storing of data:

All stored data, such as system parameters, receiver

parameters, timer status, stored messages etc. remain stored

for at least 3 months, and under optimal conditions up to 12

months. This is possible because of the integrated NiCd

battery, which is continually charged when the unit is in

operation.

It is recommended that in a case, where the unit should be

out of operation for a longer period, that you print out the

system data and the NAVTEX parameters and file them.

Should their be a loss of data, you can re-enter the old data

from the print out.

8.5. Deletion of Memory Store and RESET

All programmed system parameter data can be deleted i.e.

can be reset to the standard parameters. Equally, all stored

messages can be deleted. In this case the programmed timer

status, navigation log status and NAVTEX parameters will also

be deleted. It is therefore recommended, that you

print out

the system and NAVTEX status, before you commence this

function (see chapters 8.4. and 5.8.)

To activate the deletion function:

1. switch off the unit by turning <OFF>

2. press and hold key <CLEAR> and

3. switch unit back on

4. release the <CLEAR> key briefly and

5. repress <CLEAR>