Operation Manual

9. Installation
9.1. Delivery contents
Please check, that the following contents, necessary for the
installation of the FMD 20 are supplied:
x 1 pc pre-assembled power connection cable
x 2 pcs universal mounting brackets
x 4 pcs self holding spacers
x 4 pcs lock washers M5
x 4 pcs t thumbscrews M5
x 1 pc spare fuse 2A slow-blow 5 x 20mm
x 1 pc fuse, 300mA slow-blow 5 x 20mm (active antenna)
x 1 pc mounting hole template
x 1 pc instruction manual
9.2. Installation of unit
The two universal mounting brackets allow:
x Desk top fitting
x wall fitting
x ceiling fitting
Additionally the FMD25 can be fitted at 4 different angles. Screw the
brackets with the 4 screws to the wall or ceiling, using the adhesive
template in order to bore the holes in the correct positions.
On each side of the FMD25, there are two M5 threaded holes for
fitting at the required angle with the thumb screws. Beforehand,
press the self-holding spacers into the selected holes. These keep the
brackets at a defined distance from the casing and has been
accounted for in the template.
Before boring the holes, we recommend you to attach the brackets,
power supply and antenna cables, and select the final mounting
position.
Using the template, bore the holes in the exact positions and screw
on the brackets. Hold the FMD25 at the selected angle and attach
with the thumb screws into the holes with the spacers.
page 9-1 FMD25 10/99