User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 75 of 85 FBN Doc #: FBN-0125_04v05
6. SNMP Management Interface
6.1 Description of SNMP
Note that the SNMP agent is not enabled by default, and it must be enabled from this GUI webpage before it
can accept SNMP messages. The settings which must be enabled on the GUI before using SNMP are as follows:
Webpage: “Admin/Management/SNMP” -> Enable SNMP v1/2c and Traps
Webpage: “Admin/Management/SNMP/SNMPv1/2c” -> Set Trap destination(s)
Webpage: “Admin/Unit” -> Enable SNMP Service
The SNMP Agent is compatible with SNMPv1 and SNMPv2c. The SNMP Configuration is as follows:
•
Enable Agent The agent will respond to SNMP v1/2c requests GET/SET/GET-NEXT and GET-BULK
•
Enable Traps The agent will send traps to the configured trap destinations.
•
Trap Destinations Up to three destination are possible, each requiring:
•
IPv4 Address A valid IP address of the receiving management system.
Note: The IP address must be valid and reachable.
•
Community The community string sent in each trap to this destination, this is used by management
systems that require authentication using the trap community string.
•
Communities SNMPv1/v2c community strings for read-only and read-write operations when
accessing MIB object via an SNMP management system.
•
Read Community The community string used for read access
•
Write Community The community string used for write access
The following MIBs should be loaded into communicating network management tools:
Table 4 - V1000 MIB Compliance Table
MIB
Module
Usage
RFC1213-MIB
MIB-II
Standard MIB-II
IF-MIB
ifMIB
For SNMPv2c linkUp, linkDown notifications only
interfaces supported as part of MIB-II.
SNMP-v2-MIB
snmpMIB
System group including SNMP resources. SNMP Traps
including well known traps e.g coldStart.
SUB10SYSTEMS-MIB-
201509240000Z.mib
Sub10Systems
The Sub10 Systems enterprise MIB for CM, FM and PM
network management.
liberator-v320
LIBERATOR-MIB
Sub10 Systems V320 enterprise MIB for backwards
compatibility.
Note: V320 MIB compatibility mode is disabled by
default. It can be enabled by setting the
SUB10SYSTEMS-MIB object
sub10UnitMgmtSnmpV320Mib = stateEnabled(1)