User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 61 of 85 FBN Doc #: FBN-0125_04v05
 Consumer: Use this setting if the remote end of the link is to be configured as “Provider”. Note that only
one end of the link may be configured as SyncE “Consumer”.
Figure 72 - Timing Configuration Page (SyncE and 1588)
On the Dual-port version, it is necessary to choose the timing source port if Provider is selected (Primary or
Secondary port for the Provider).
On the Dual-port version only, IEEE1588 mode may be configured as either:
 None (1588 not active)
 Transparent (1588v2 Transparent Clock, requiring that one end of the link must be configured with
SyncE setting as “Consumer”).
5.4.12 Administration - Unit