User's Manual
Liberator-V1000 User Manual Rev 04v05
Page 57 of 85 FBN Doc #: FBN-0125_04v05
Figure 66 - Confirmation that new user was added
Figure 67 - New User Added
5.4.9 Administration – Security/Encryption
This page is only visible if a valid AES Licence Key has been applied to the terminal. See Section 5.4.10 to
apply the Licence Key, which will then make the “Encryption” option visible.
In order to activate the AES encryption after the AES Licence Key has been applied (this procedure MUST be
followed at both ends of the link, always update the REMOTE END FIRST):
1. In the “Encryption Algorithm” Drop-down box, select “AES-256”.
2. Enter a new AES 256 Encryption Key. This is a set of alphanumeric characters which MUST be the
same at both ends of the link. The user may choose any set of characters they wish from (0 to 9) and
(a to z).
3. Enter the same Encryption Key again in the second box to verify that it is correct.
4. Press “Apply” and the Encryption Key will now come into operation, and the data will be encrypted
over the air in the transmit direction only.