User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 52 of 85 FBN Doc #: FBN-0125_04v05
Note: The ‘User Role’ restricts access via VACM (View Based Access Model) which is fixed depending on the user’s
assigned group.
•
SNMPv3 Notification Target Security Defines each target for sending SNMP notifications.

Target Name User defined name up to 32 characters.

Target Address Target IP Address.
•
User:Group The User and Group used to send the notification.
5.4.6 Administration Management – Time
The Time page is used to set the internal real time clock on the radio terminal. The real-time clock is used to
timestamp events in logs and SNMP traps.
Figure 57 - Setting the real-time clock manually
The first option is simply to set the System Clock date and time, and press the “Apply” button in the “System
Clock” section of the page.
For greater accuracy the operator can synchronise the internal real time clock to an NTP (Network Time
Protocol) time server. To enable the use of an NTP time server the operator must tick the “NTP Enabled” box,
and also enter the IP address of an accessible NTP time server into the “Server 1” field (and also “Server 2”
field if an alternative server is available), and then press the “Apply” button in the “NTP” section of the page.