User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 51 of 85 FBN Doc #: FBN-0125_04v05

MAC Address The MAC address of the unit

Text Plain text up to 18 characters in length.
•
SNMP Engine Id Text – Plain text up to 18 characters in length if Engine Id format is selected as ‘Text’
•
SNMPv3 Group Security Policy - Configure authentication and privacy protocols per user group.
•
Auth Protocol

No Auth Authentication disabled for the group

MD5 Message Digest algorithm authentication

SHA-1 Secure Hash Algorithm authentication
•
Priv Protocol

No Priv Privacy disabled for the group

DES Data Encryption Standard

AES Advanced Encryption Standard
AES encryption will only be permitted if the unit has a valid AES encryption license key installed (note that
only Dual-port versions and certain Single-port versions are hardware-capable for AES encryption). An AES-
256 upgrade may be purchased, which will only be supplied if there is official permission to export AES
encryption to the country of operation. If there is no AES license key installed, then the following message is
displayed if “AES” is selected:
Figure 56 - Error message displayed if “AES” is selected without a valid AES license key.
•
SNMPv3 Access Security Restricts access to the specified management stations.

Access Name User defined name up to 32 characters

Access Address IP Address
•
SNMPv3 User Security Defines each user (maximum 10) in the user based security model (USM).

User Name User defined name up to 32 characters

User Role The user’s group defining the access rights to certain parts of the MIB
- Operation User has read-only access
- Administration User has read-write access but cannot upload new firmware or reboot the unit
- Maintenance Full Access

Auth Password The password for the configured authentication protocol (not for ‘No Auth’)

Verify Password Verify the Auth Password

Auth Password The password for the configured authentication protocol (not for ‘No Priv)

Verify Password Verify the Priv Password