User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 50 of 85 FBN Doc #: FBN-0125_04v05
-
SNMP ReadOnly A security feature which prohibits SNMP Sets. If this is 'Enabled' all SNMP Set
requests will be rejected.
-
Read Community The community string used for read access (Get/GetNext). Default setting to
use is “public”.
-
Write Community The community string used for write access (Set). Default setting to use is
“private”.
•
Trap Destinations Up to three destination are possible, each requiring:
-
IPv4 Address A valid IP address of the receiving management system.
Note: The IP address must be valid and reachable.
-
Community The trap community string sent in each trap to this destination, this is used by
management systems that require authentication of the trap community.
5.4.5.4 Administration - Management – SNMP – SNMPv3
Configure the SNMP v3 agent supports User Based Model (USM) security. Note that the SNMPv3 configuration
is only supported through the web GUI and the Sub10 Systems enterprise MIB. The configuration may be
viewed but not changed via the standard SNMPv3 MIBs – this will be supported in a later release.
Figure 55 - SNMPv3 settings
•
SNMPv3 Engine Id - Configure the format of the SNMP v3 Engine Id.
•
SNMP Engine Id Format

IPv4 Address The IPv4 Address of the unit

IPv6 Address (Not Available)