User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 49 of 85 FBN Doc #: FBN-0125_04v05
Figure 53 - Configuring SNMP
The SNMP Agent is compatible with SNMPv1, SNMPv2c and SNMPv3.
•
SNMP v1/2c Enables the SNMP v1/2c agent and configuration options.
•
SNMP v3 Enables the SNMP v3 agent and configuration options.
•
SNMP Traps The SNMP agent will send traps to the configured trap destinations.
Selection of SNMPv3 requires confirmation, otherwise the setting will be rolled back to its original value after
the configured rollback timeout. Note that the SNMP agent is not enabled by default, and it must be enabled
from this GUI webpage before it can accept SNMP messages. The settings which must be enabled on the GUI
before using SNMP are as follows:
1. Webpage: “Admin/Management/SNMP” -> Enable SNMP v1/2c and Traps
2. Webpage: “Admin/Management/SNMP/SNMPv1/2c” -> Set Trap destination(s)
3. Webpage: “Admin/Unit” -> Enable SNMP Service
5.4.5.3 Administration - Management – SNMP – SNMPv1/2c
Configure the SNMP v1/2c agent community strings and trap destinations.
Figure 54 - SNMPv1/v2c settings
•
Communities SNMPv1/v2c community strings for read-only and read-write operations when
accessing MIB objects via SNMP.