User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 45 of 85 FBN Doc #: FBN-0125_04v05
Figure 49 - Radio Interface: Transmit Power, ATPC, Modulation Mode,
Frequency Channel and Data-rate throttling selections
5.4.4.1 Frequency Selection - The Tx/Rx channels can be selected.
WARNING: it is the responsibility of the installer to ensure that the correct frequency channels are selected in
accordance with the in-country radio regulations.
On V1000 Single-port, The “A” end can be set to transmit on 58.5, 59.0 or 59.5GHz and the “B” end to transmit
on 61.5, 62.0 or 62.5GHz. The 3 channels on Tx Low and Tx High are non-overlapping.
On V1000 Dual-port, The “A” end can be set to transmit on 58.0, 58.5, 59.0 or 59.5GHz and the “B” end to
transmit on 61.5, 62.0, 62.5 or 63.0GHz. The 4 channels on Tx Low and Tx High are non-overlapping.