User's Manual

Liberator-V1000 User Manual Rev 04v05
Page 36 of 85 FBN Doc #: FBN-0125_04v05
Figure 38 - Status – System Info Page
Local & Remote Terminals
•
Serial Number – Serial number of the local radio terminal
•
MAC Address – MAC Address of the local radio terminal
•
IP address – IP address of the management agent (very useful if the IP address of the remote
terminal has been forgotten)
•
Management VLAN – VLAN ID of the management agent VLAN (if set)
•
Site Name – This is a free-text field that can be used to store the Site Name (optional).
•
Link Name – This is a free-text field that can be used to store the Link Name (optional).
•
Terminal Name – This is a free-text field that can be used to store the Terminal Name (optional).
•
Link ID – The Link ID must be the same at both ends of the link, and should not be used for any other
link. Note that if the Link ID is not the same at both ends of the link, then the radio link may not be
established between the 2 ends. A warning message will be displayed if the LinkID is not the same at
both ends. Suggest to leave this blank if not required.
•
Software Version – Software version running in the active memory bank.
•
Transmit / Receive Modulation Mode – Modulation modes used in Tx / Rx (QPSK or 8PSK)
•
Air Data Rate – Capacity (full-duplex) user data rate. This may be increased up to a maximum of
1000Mbps full-duplex by purchasing a licence key upgrade.
•
Regulatory – The regulatory region is either “FCC” or “NON-FCC”. Only radios marked as “FCC” may be
sold and operated in the USA or Canada.
•
Current Time – The system clock time