Installation Guide

IBR Installation Guide
Page 30 of 32 Doc # 770-00001-3
Aug. 30, 2013
1.5. Pole mounting straps
Mounting IBR on a pole or mast simply requires attaching pole bands to the bracket as shown
below. Be careful to not damage the bracket when tightening the bands.
Pole straps can be attached either to the ends of the plate or to the flanges in the center of the
plate as appropriate for the diameter of the mast to which it is being attached.
Pole bands are not included. The bracket will accept steel bands up to ¾” wide.
1.6. Mounting Instructions
When the mounting plate has been affixed to IBR and the wall/pole plate has been mounted in its
permanent location, the last step is to hang the IBR onto the mounting plate by first inserting the
tabs on the top of the IBR mounting plate into the slots at the top of the wall/pole plate shown by
the red arrows in the figure below. Finally, mate the two plates together and secure using two
M6x10 bolts shown by the white arrows in the figure below.