Installation Guide

IBR Installation Guide
Page 28 of 32 Doc # 770-00001-3
Aug. 30, 2013
Appendix A – IBR Mounting Brackets
A 1. Wall/Pole Mounting Bracket
Fastback Networks’ wall/pole mounting bracket assembly can be used to mount IBR on poles, on
the sides of buildings, or in other outdoor locations. The first illustration below shows a fully
assembled bracket with pole straps attached to IBR, and the second illustration shows IBR
mounted on a mast using the same bracket.
1.1. Ordering Information
The Wall/Pole Mounting Bracket Assembly consists of the following components:
o IBR mounting plate
o Four M8x12 bolts for attaching IBR to mounting plate
o Wall/Pole mounting plate
o Two M6x10 bolts for attaching the two plates to one another
1.2. IBR Mounting Plate
The plate shown below attaches directly to the mounting lugs on IBR. This plate should be firmly
mounted to IBR before IBR is raised to its mounting location. Four bolts, size M8 x12, with lock
washers are required to mount this bracket to IBR.
The raised edges on the top side of the plate mate with the heat sinks on IBR. The plate attaches
to the wall/pole plate via hooks on one side and two bolts, size M6x10, with lock washers on the
other side.