Installation Manual

IBRInstallationGuide
 Page24of40 Doc#770‐00001‐13
 Sept.21,2014
6.6 SurgeSuppressorInstallation
InstallasurgesuppressorbetweenthePoE
+
injectorandIBRasnearaspossibletothePoE
+
injector.


Thesurgesuppressorshouldbeinstalledaheadofthecableingresstotheenclosureorstructurehousingthe
switchinordertomaximizeprotectiontotheswitch.Thesurgesuppressorshouldbeconnectedtoatrue
earthgroundwithmaterialsthatmeetthemanufacturer’sspecifications.
NOTE:ThetotallengthofcablebetweentheswitchandIBRmustnotexceedonehundredmeters(100m).
6.7 CommunicationwithIBRViatheSerialPort,Telnet,orSSH(Optional)
AlocaloperatorcanconfigureIBRbyconnectingtheFastback‐suppliedserialcabletoaPCwithaDB‐9RS‐
232connection.Ifsuchaconnectionisnotavailable,aUSB‐to‐serialconvertermaybeused.(Seethesection
titledSerialConsole.)
TheoperatormayalsotelnetorSSHtoaccesstheCLI.TheIBRdefaultIPaddressis192.168.128.101or
192.168.128.102forIBR‐1000‐57‐JPandIBR‐1000‐75‐JP,respectively.ConnectaPCviaEthernetcableto
thePoE+injector.IBRPort1andPort2aredisabledbydefault.OnlyPort0isaccessibleviatheconnection
onthePoE+supply.EnsurethePChasanIPaddressintherangeof192.168.128.<0‐254>.Immediatelyafter
configuringtheIBRIPaddressasindicatedbelow,changetheIPaddressonthePCtomatchthesubnet
configuredontheIBR.
OncetheoperatorhasaccesstotheCLI,setthesamelink‐IDonbothendsofthelinktoensurethelink
doesn’taccidentallycommunicatewithotherFastbacklinks.SettinganIPaddressallowsremoteIBRaccess.
Thefollowingarethecommandstosetthelink‐idandtheIPaddress:

Promp
t
 Command
IBR102login:
admin
Password:
(factor
y
‐
s
e
t
passwordisfastback)
IBR102>
enable
Password:
(factor
y
‐
s
e
t
passwordisfastback)
IBR102#
configuretermina
l
IBR102(config)#
interfaceradio0
IBR102(config‐if‐rad0)#
link‐id<yourlink‐id>
IBR102(config)#
interfacevlan1
IBR102(config‐vlan‐1)#
ipaddress<IPaddr><Netmask>
IBR102(config‐vlan‐1)#
ipdefaul
t
‐
g
ateway<GWaddr>
IBR102(config)#exit 
IBR102#
copyrunning‐configstartup‐config
IBR102# 
NOTE:Whentheserialportisnotinuse,aweatherproofprotectivecovershouldbeinstalledovertheserial
connectoronIBR.
6.8 LinkEstablishment
IBRwillautomaticallyselectthebestcombinationofchannelfrequenciesandbandwidthforalink.
 Waitforradiostofinishbootingandestablishingalink.
 UsetheCLIcommandshownbelowtoverifythatalinkhasbeenestablished.