Installation Manual

IBRInstallationGuide
 Page13of40 Doc#770‐00001‐13
 Sept.21,2014
connectingapowersource,positionthetwoIBRssothattheyaretiltedawayfromeachother,facing
downward,andseparatedbyatleastonemeter.
 IBRdoesnothaveapoweron/offswitch,eitherinhardwareorsoftware.Whenpowerisappliedtothe
unit,IBRwillbeina“poweron”conditionandthesystemLEDbesidethege0portconnectorwillbe
illuminated.
ApplypowertoeachIBRusingaPoE
+
sourceconnectedtoGigabitEthernetinterface0.AlthoughPoE
+

sourcescanbeappliedharmlesslytoanyport,onlyge0canbeusedtopowerIBR.
4.2 CLIPrivilegedMode
EnterPrivilegedmodebyenteringtheenablecommand:
IBR102>enable
Thefactory‐setpasswordforenteringPrivilegedmodeisfastback.ThePrivilegedModecommandprompt,
withIBR102ashostnamewillbe:
 IBR102#
ThefollowingCLIcommandsareavailableinPrivilegedmode.
PrivilegedModeCommands
Command Description
IBR102# 
 ! Comments
 clear Resetfunctions
alarms Clearalarmhistory
config Resettofactorydefaults
counters Clearcountersononeorallinterfaces
 configureterminal EnterGlobalConfigmodetomanagedeviceparameters
 copy Copyafile(e.g.,running‐config)
 ethernet Ethernetsubcommands
 exit ReturntoUserMode
 ping[string] Sendmessagestonetworkhosts[hostnameorIPaddress]
 reload Halt&performacoldrestart
 show Showrunningsysteminfo(seeCLIGuideforacompletelistofshowcmds)
 telnet IPaddressorhostnameofaremotesystem
 traceroute Printtheroutepacketstracetonetworkhost
ip IPv4
ipv6 IPv6
[string] HostnameorIPaddresstotracetheroute
 upgrade Upgradecommands
http Upgradehttp(enterA.B.C.D[/mask]oranyhttpserverIPaddress)
sftp Upgradesftp(enterA.B.C.D[/mask]oranysftpserverIPaddress)
tftp Upgradetftp(enterA.B.C.D[/mask]oranytftpserverIPaddress)
ForadetaileddiscussionofCLIcommands,refertotheCLIGuide.
4.3 RSL
ChecktheRSLoneachIBRusingthefollowingCLIcommandinthePrivilegedmode:
IBR102#showinterfaceradio0status
RSLshouldbe‐36dBmorless.IfRSLisgreaterthan‐36dBm(e.g.,‐30dBm)oneitherIBR,thereceived
signallevelistoohighandgreaterseparationoftheIBRsisrecommendedtoavoidreceiversaturation.
4.4 ManagementTraffic
IBRinterfacesshouldbeconfiguredinsuchawayastoseparateinternalmanagementtrafficfromuserdata
traffic(i.e.,preventmanagementtrafficfrombeingsentoverthenetwork).Thefollowingsequenceof