Owner's Manual

FOR ACOUSTICALLY SEALING TRANSDUCER RINGS 1. Separate the three pieces of Foam (101, 102, 103)
PATENT #8739921 ; _ .>'· - --... . 2. Clean the back panel of the door, remove the backing paper from 103 and adhere
i .. / directly behind the speaker to the outermost panel in the door. This will help absorb II'\
.. - .. _ the rear W8V9 and redUCe panel Vibration . (Thisstepisoptionalasitispossibletoabsorbmoisture) ~~~~~~
:~ C:; ::
5
;::
.( · 3. With a razor blade cut circumferentially 102 down to approximately 1 /4". Remove ..a
, .,_._.._ backing paper and adhere to mounting surface of speaker. This will decouple the g:
speaker from its substrate and prevent front and rear wave cancellation. g:
4. Using standard installation procedures wire and mount speaker. N
5. Clean around the outside edge of the speaker, remove the backing paper from 101
and adhere 101 directly around the speaker. Test fit panel for fitment. If needed
trim
101 circumferentially until proper fitment is achieved. It should press tightly to
the door panel. This will focus all the sound into the cabin, prevent panel vibration
600 and destructive wave ;nterference giving you noticeably improved speaker perform-
I;.A.S.T57
602 ance and less panel resonance.